Cooper M3000 Guide de l'utilisateur télécharger pdf (Page 47)

Chapter 2 Setting Up XSCF 2-7

8. Configure the network.

■ Perform the applynetwork(8) command to apply the network settings. To complete the

network settings, the XSCF reset is required. Go to the next step when you reset it later.

When you want to reset it now, perform the rebootxscf(8) command to apply the

settings. Then, the XSCF reset is done and the XSCF session is disconnected. Please

connect the XSCF and log in to the XSCF again.

■ Here, when you set up the XSCF by the XSCF-LAN connection, please change the cable

from the serial port to the XSCF-LAN port. (Change the serial cable to the LAN cable.)

When you use the controller that converts the RS-232C interface and LAN interface, you

do not need to change the cable. Reconnect to the XSCF using the new user account and

the new IP address and login to the XSCF again.

For details on connecting the SSH, telnet, and serial port, and login to the XSCF, see

Chapter 3. Moreover, the telnet connection is not a secure connection protocol. We

recommend that you use SSH.

During login using SSH on XSCF Shell (Ethernet connection), you are prompted to

confirm the authenticity of the fingerprint of the host public key. The reply is "yes" if the

fingerprint is the same as the memo in Step 6. If the reply is not the same, please confirm

that the IP address is correct and not duplicated. There is a possibility that IP address

spoofing has occurred.

• Display and set the DSCP.

• Display XSCF network settings (enable/disable, IP

address, netmask) and configure/remove an XSCF

network.

showdscp(8), setdscp(8),

shownetwork(8),

setnetwork(8)

• Display and set XSCF host name. showhostname(8),

sethostname(8)

• Display XSCF route settings (destination IP address,

gateway, netmask, interface) and configure an XSCF

route.

showroute(8), setroute(8)

• Display and make the DNS settings (name servers, search

paths, add/delete).

shownameserver(8) ,

setnameserver(8)

• Display and set the IP packet filtering rules. showpacketfilters(8) ,

setpacketfilters(8)

• Apply network settings. applynetwork(8)

(See Section 2.2.1, “Network

Configuration” on page 2-16)

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 431 432

Pas de commentaire

Cooper M3000 Guide de l'utilisateur Page 47