Menvier40/100 Installer Menu
Page 29
1
Appears only when device learned in.
2
Appears only in a Ward based system.
3
Appears only in a Level Setting system.
4
Appears only if Exit Mode is “Final Door Set”, “Lock Set” or “Exit Terminate”.
5
Appears only if Exit Mode is “Timed Set” or “Silent Set”.
6
Appears only when System Options – Confirmation – Confirmation Mode is “Basic”.
7
Appears only when System Options – Confirmation – Confirmation Mode is “DD243” or
“BS8243”.
8
Appears only when System Options – Confirmation – Confirmation Mode is “BS8243”.
9
Appears only when System Options – Masking is “On”.
10
There is one Shunt Group available on Menvier40, five available on Menvier100.
11
Appears here only in a part setting system.
12
Options visible depend on communications module fitted, see Table 2 below.
13
Appears only when Report Type=Fast Format
14
Appears when Report Type=CID or SIA
15
Appears only when Static Test call disabled.
16
Appears only when Dynamic Test call is disabled.
17
Appears only when Report Type = Fast Format and Confirmation Mode = Basic.
18
Shows “None” if no module fitted.
Table 2. Menu Options Available with Communications Modules
Commentaires sur ces manuels