Cooper Menvier 100 Guide de l'utilisateur télécharger pdf (Page 25)

Menvier40/100 Installation

Page 21

21

Figure

36

Fitting the ADSL01 Filter.

Note: If you remove the ADSL01 filter then

re-fit the jumpers to the outermost pairs of

pins. If you fail to re-fit the jumpers the

internal communicator will not connect to

the phone line.

Step 9. Fit a Plug-By

Communicator

The control unit can be connected to a

separate communicator or speech dialler

(for example, the Menvier SD2). Figure 37

shows the connections provided by the

communications wiring harness. Note that

the output types shown in Figure 37 are the

Factory default types. See the

Menvier40/100/300 Engineering Guide for

details on how to change the defaults.

Figure

37

Plug-By Communicator Wiring

Note: Comms O/P4 will be active when the

system is unset. This is normal.

To fit a communicator, follow the

instructions below.

Caution: Follow the instructions in the order

shown, or you may damage the

control unit and/or communicator.

1. Disconnect mains power from the

control unit, remove the case lid, and

disconnect the battery (if the system

has already been installed).

2. Make any necessary connections from

the communicator to the communication

wiring harness. The default is a 12V

positive voltage when the output is

inactive.

Refer to the next section if you are

using a dual-path communicator.

3. Plug the Communication Wiring Harness

onto the communications connector on

the main PCB.

If the system has already been installed:

4. Re-connect the battery.

5. Fit the case lid.

6. Apply mains power.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 37 38

Commentaires sur ces manuels

Pas de commentaire