Cooper TS590 Instructions d'exploitation télécharger pdf (Page 6)

Full Setting The System

The full setting procedure can be initiated from any remote keypad (if more than one is

fitted). Before attempting to full set the alarm system ensure that all movement detectors

are unobstructed and all doors, and windows are secure.

1. From the unset (open) mode enter

your passcode.

2. After 5 seconds theexit sounderwill

start and the display will show the

remaining exit time.

3. Leave the premises by the

designated exit route, close the

final door and press the exit

terminator button (if fitted). The

system is fully set when the exit

sounder stops.

To abandon the setting process any time, simply re-enter your passcode.

If the display shows “9999" at step 2 the system is configured set by exit

terminator or on closure of the last exit circuit.

If an attempt is made to full set the system whilst one or more circuits are

active (such as a door being open) the display at step (2) will indicate the

circuit(s) that are in fault and internal sounder generates an interrupted

tone. The fault must be cleared before the setting procedure can be

completed. If the fault is still present at the end of the exit time an internal

alarmwillbegenerated.Iffitted,theexternalstrobelightwillflashindicating

thatthe systemhas “Failedto set”. To prevent thisalarm simplyre-enter your

passcode before the exit timer expires.

SYSTEM OPEN

17:30 01 Jan

Press ENT to

Select Functions

Please Exit Now.

Time left > 0035

SYSTEM SET

17:31 01 JAN

? ? ? ?

LCD Remote

NOTES

1 2 3 4 5 6 7 8 9 10 11 ... 39 40

Pas de commentaire

Cooper TS590 Instructions d'exploitation Page 6