Cooper TS590 Instructions d'exploitation télécharger pdf (Page 10)

Resetting After an Alarm

Your alarm company will have programmed the system to be either “User Reset”,

“Engineer Reset” or “Remote Reset”, consult your alarm company if you are not sure.

User Reset

If your system has been programmed as user reset, alarms can be reset by any user that

has a valid passcode.

From step (3) of “Unsetting After an Alarm”, proceed as follows:

1. Enter your passcode and within 5

seconds press [ESC].

2. The system is now reset and back in the

open mode. After 5 seconds the

“SYSTEM OPEN” message will disappear

andthedisplay will showthe time, (date

and banner text, LCD only).

Engineer Reset

If your system is programmed as engineer reset, alarms can only be reset by your alarm

company.

From step (3) of “Unsetting After an Alarm”, proceed as follows:

1. The display will alternate between the

circuit that caused the alarm and the

“Call Engineer To Reset System”

message. The internal sounders will also

generate a beep every minute to

remind you that the system requires

resetting.

2. To silence the beeps enter your

passcode.

3. Contact your alarm company:

SYSTEM OPEN

17:30 01 Jan

ALARM 03

17:31.02 01/01

? ? ? ?1

ESC

LCD Remote

CALL ENGINEER TO

RESET SYSTEM

ALARM 03

17:31.02 01/01

? ? ? ?

LCD Remote

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 39 40

Pas de commentaire

Cooper TS590 Instructions d'exploitation Page 10